|
|
This article is specific to implementations using Updox Central. |
Add an Updox Central Printer
Location: Your Computer
You can easily transfer documents from your computer into your Workspace by printing to an Updox virtual printer.
|
|
This article is specific to implementations using Updox Central. |
|
|
The printer must be installed as a local printer on the same computer where Updox Central is installed. |
Microsoft Windows
1.Open the Windows Control Panel (can be found under the Start menu).
2.Open the printers screen.
In Windows XP this section is called Printers and Faxes.
In Windows Vista this section is called Printers
In Windows 7 and Windows 8 this section is called Devices and Printers
3.Click the Add a Printer button (In Windows 8 click The printer that I want isn't listed).
4.Select add a local printer.
5.Uncheck the Automatically detect and install... checkbox, if present.
6.Click Next.
7.Indicate you want to use an existing port.
8.For the port, choose Updox_9100 (if not listed, see the instructions below).
9.Click Next.
10.For the Manufacturer, select HP.
11.For the Printer, select one of the following (if the printer isn’t listed contact Updox Support for assistance):
•Windows XP : HP ColorLaserJet 5/5M PS
•Windows Vista: HP ColorLaserJet 5/5M PS or HP ColorLaserJet 2800 Series PS
•Windows 7 : HP ColorLaserJet 5/5M PS or HP ColorLaserJet 2800 Series PS
•Windows 8 : HP ColorLaserJet 2800 Series PS or HP ColorLaserJet 3800 PS Class Driver
12.Click Next.
13.If asked, click Keep existing driver or Use the driver that is currently installed.
14.Enter the name of this virtual printer (e.g. Updox).
15.Depending on your version of Windows, you may also be asked the following questions (the order may vary):
•Make this the default printer? Click, No. (most common)
•Share this printer? Click, Yes.
•Print a test page? Click Yes.
Updox_9100 Port Isn’t Listed
If Updox_9100 isn’t an existing port, then:
a)Select the Create new port option (instead of Use existing port).
b)For Type of Port, select Standard TCP/IP.
c)Click Next.
d)For the Printer Hostname or IP Address, enter localhost.
e)For the Port Name, enter Updox_9100.
f)Uncheck the Query the printer... checkbox (if present).
g)Click Next.
h)Windows will try (unsuccessfully) to detect the printer.
This usually takes 30-40 seconds.
It will state it was unable to detect the device and that additional port information is needed.
i)Click the Custom option checkbox (you do not need to click the Settings button).
j)Click Next (on Windows XP, also click Finish) to return to the printer setup.
k)Resume the Windows Virtual Printer setup at Step 10 above.
.jpg){kind=small}